This product is no longer in production.
The HT3/HTX3 Series pumps are small, rugged, submersible, cast iron pumps with non-clog vortex impellers, solids handling capability to 3/4", and the ability to handle high temperature discharge effluent.
1-year limited warranty
BODY CONSTRUCTION: Cast Iron
HORSEPOWER: 1/3 HP
MAXIMUM HEAD: 22' (20' at higher temps)
MAXIMUM CAPACITY: 45' (44' at higher temps)
FLOW AT 10' LIFT: 43 GPM (40 GPM at higher temps)
SWITCH: Tethered float, On: 13.5" / Off: 4.5"
MOTOR: 1/3 HP, 1550 RPM, Oil-filled. Built in thermal overload protection with automatic reset.
IMPELLER: Cast iron
SHAFT SEAL: Type 6A or equal, Buna-N elastomers, carbon and ceramic sealing faces, stainless steel metal parts
BEARINGS: Lower ball, upper sleeve type, oil lubricated
EXTERIOR HARDWARE: Stainless steel
MINIMUM SUMP DIAMETER: 18” (457mm)
DISCHARGE SIZE: 1-1/2" (38mm) NPT
MAXIMUM SOLIDS HANDLING CAPACITY: 3/4” (19mm)
AMP DRAW: 13 amps max load
POWER CORD: 20' oil and water resistant 16-3 SJOOW-A/SJOW with integrally grounded three-prong plug
VOLTAGE: 115 Volt, single-phase, 60 Hz.
MAXIMUM LIQUID TEMP: HT: 194°F (90°C) / HTX: 200°F (93°C)