Print  print

Performance

GET BETTER PRESSURE!

The PENTEK INTELLIDRIVETM Water Pressure Control Center automatically adjusts motor speeds to meet changes in water demand. Instantaneous feedback from an electronic pressure transducer instructs the drive to change the submersible well pump motor speed to maintain constant pressure throughout the system.

Product Images

CSA ApprovedCertified NSF ANSI 61
Model HS Series - 10 thru 50 GPM

4" Submersible, Stainless Steel, 1/2 thru 10 HP, 2- & 3-Wire

Stainless Steel series pumps deliver efficient, dependable performance even in rough, aggressive water.

Key Features
  • SignaSeal staging system incorporates a harder-than-sand ceramic wear surface and a floating impeller design - which together literally pulverize sand and small debris. This proven feature reduces lock-ups, dry-runs, and abrasive wear.
  • Floating Stage Design is engineered to transmit forces away from the motor bearing and through the pump housing. This reduces premature wear and misalignment.
  • Fully-Enclosed Shaft Bearing creates a pressure zone that prevents sand & water from entering. Eliminates wear and misalignment.
  • Wear Ring forms a seal between impeller hub and suction cap for low friction and no unwanted recirculation of water.
  • Corrosion resistant 300 grade stainless steel discharge for durability in aggressive water.
  • Large octagon wrench area for ease of installation.
  • 50 GPM series does not include motor.
Warranty

1-year limited warranty

Specifications    
Resources    

 

HORSEPOWER:  Available in 1/2 thru 1-1/2 HP

PERFORMANCE SERIES:  10, 15, 20, 30, and 50 GPM Series Available

NUMBER OF STAGES:  4 - 38 (model dependent)

VOLTAGE:  115v, 230v 1- or 3-phase, and 460v 3-phase

NUMBER OF WIRES:  2-wire and 3-wire available

SHELL:  Stainless steel

DIAMETER:  3-7/8"

LENGTH:  22-1/4" to 33-1/2"

WEIGHT:  27 to 43 lbs

DISCHARGE:  thru 20 GPM: 1-1/4" NPT / 30 & 50 GPM: 2" Stainless steel

DISCHARGE BEARING:  Nylatron®

IMPELLERS:  Acetal

DIFFUSERS:  Polycarbonate

SUCTION CAPS:  Polycarbonate w/ stainless steel insert

THRUST PADS:  Proprietary spec

SHAFT END COUPLING:  Stainless steel

INTAKE:  Stainless steel

INTAKE SCREEN:  Stainless steel

CABLE GUARD:  Stainless steel

CHECK VALVE:  Acetal

:  

:  . . . Nylatron® is a registered trademark of Quadrant Engineering Plastic Products

Owner's Manual: 4" Submersible Pump
DOWNLOAD MANUAL
Sell Sheet: HS Series 4" Submersibles
DOWNLOAD SHEETDOWNLOAD SHEET
Selection Guide: 4" Submersible Cable
DOWNLOAD GUIDEDOWNLOAD HS CABLE GUARD
More Resources Available In Our Resource Center
GO TO RESOURCE CENTEROPEN RESOURCE CENTER IN A NEW WINDOW